Assembly Instructions - ergoline Genesis Classic 650 Owner's Manual

Disassembly Instructions
46. Illustration A20 It is not required but advised,
due to the weight of the rear panel assembly, to
remove the ballast trays A prior to transporting
the rear assembly into the tanning room. Prior to
removing ballast trays all electrical connections
must be disconnected. Detach ballast trays A
from rear panel by removing the 8mm philips
screws B and lift out of place.
47. Illustration A20 Detach the rear panel
assembly by removing the self tapping screws
from the lower cross member C.
Illustration A20

Assembly Instructions

1. Illustration A20 Install Rear panel assembly in
tanning room. Locate panel assembly in center of
room allowing sufficient access to rear of panel
for connection to electrical service.
2. Illustration A20 Attach the ballast trays A to
the rear panel assembly with 8 mm philips
screws if removed prior to installation.
3. Illustration A21 Install left base leg section to
rear panel assembly. Align the slot in the left leg
section with tabs in the rear panel and slide leg
section into place. Slide rear profile retainer C
down to secure leg section.
Illustration A21
4. Illustration A21 Complete leg section attach-
ment by securing to the rear panel with two self
tapping philips screws A and B located under the
top of the rear panel assembly.
5. Repeat Steps 3 and 4 for right base leg
section.
6. Illustration A22 Attach profile retaining frame
C to base with four self tapping philips screws B.
Illustration A22
16