Operating Instructions; To Set Time; To Stop Unit; To Clear Time - ergoline Genesis Classic 650 Owner's Manual

Intellitan by Sun Ergoline

To Set Time

STEP 1:
STEP 2:

To Stop Unit

STEP 1:

To Clear Time

STEP 1:

Operating Instructions

Press s button to reach desired setting in minutes.
Press Start/Stop to begin operation. The session is counted down in
minutes and seconds.
NOTE: If a session delay is preprogrammed (P04), the display will begin to
flash the session time. The display will continue to flash the session time for
the duration of the session delay according to the programming or until Start/
Stop the button is pressed. If the Start/Stop button is pressed before the
session delay expires, the display will stop flashing and the session time will
begin to count down. At one (1) minute, before the start of the tanning
session, an audible beep will sound (if programmed in P02). At thirty (30)
seconds, before the start of the tanning session, another audible beep will
sound. At ten (10) seconds the audible beep will sound and continue once
each second until tanning unit lights. Once the tanning unit has started, the
session delay will not repeat on subsequent restarts.
Press Start/Stop anytime during a session. This will stop the countdown
and hold time. To restart the unit simply press Start/Stop.
Press Reset, the timer clears to read 00:00.
NOTE: If the unit is counting down, the Start/Stop button must be pressed
before resetting.