ergoline Genesis Classic 650 Owner's Manual page 18

Assembly Instructions
12. Illustration A27 Slide flange located at the
rear of the accent panel into provided grove in
back rail of canopy. Attach accent panel to
canopy with six 5mm philips screws.
13. Illustration A28 Check the lateral alignment
of the top canopy. If the canopy needs adjusting,
adjust the gap between the canopy and base with
the canopy support rods. Raise top canopy and
turn support rod clockwise to raise and counter
clockwise to lower.
14. Illustration A29 Install the two assembly
Illustration A27
rails. Position rails to the rear of slot A allowing
sufficient clearance for the base assembly
latches to fit into place.
Note: Base assembly weighs approximately 200
pounds and will require at least one person at
each end of assembly for lifting.
15. Illustration A30 Install base assembly. To
install base assembly tilt assembly to approxi-
mately a 30 degree angle and place the rollers on
the assembly rails and roll assembly evenly to
the back of rail to prevent binding. Base assem-
bly should latch into the required position.
Illustration A28
16. Check to insure base assembly will not pull
forward and remove assembly rails at this time.
Illustration A29
Illustration A30
18