To Change Parameter 27, Timer Protocol Option; To Change Parameter 28, Total Operating Cost - ergoline Genesis Classic 650 Owner's Manual

P27
Parameter 27 is the Timer Protocol Option. The default is 0 for Intellitan Protocol. The
timer protocol option allows the salon owner to change timer network protocols from the
Intellitan Network to the T-Max
For additional information please consult the T-Max documentation. This feature is only
available with software level 16 or higher.

To Change Parameter 27, Timer Protocol Option

Press Reset once then release it, the display will begin to flash. Now press s until 0001
is displayed, press Reset once and release it. Next cycle the power to the timer and
tanning unit off and back on. The T-Max Protocol is now on. To turn off this function
change parameter 27 back to 0000 using the parameter edit instructions in the T-Max
documentation. You can not use a CCS-1 or IPI with a timer using T-Max Protocol.
Now press Start/Stop once and release it to reach Parameter 28 (P28), Total Operating
Cost.
P28
Parameter 28 is the Total Operating Cost Accumulator. This parameter tracks total
operating costs of the tanning unit based upon parameter 17, session cost per minute.
This parameter is displayed in dollars and tenths and rolls over at $999.9. The Total
Operating Cost Accumulator can be reset to 0 at anytime in order to track or determine
daily, weekly, monthly, quarterly, or annual operating costs.

To Change Parameter 28, Total Operating Cost

Press Reset once then release it, the display will begin to flash. Now press s until 0000
is displayed, press Reset once and release it. The Total Operating Cost is now reset to
0 and will begin accumulating at the next session.
Now press Start/Stop once and release to reach parameter Parameter 30 (P30), Facial
Control.
1
T-Max is a registered trademark of Salon Systems, Inc./Applied Digital, Inc. Branson, MO.
1 protocol for use with the Applied Digital T-Max Manager.