ergoline Genesis Classic 650 Owner's Manual page 14

Disassembly Instructions
28. Illustration A13 Locate and insert the two
assembly rails. The rail must fit securely into the
slot A in the rear of unit under the base assembly
rollers. Secure the each rail with a #8 self tapping
screw.
29. Base assembly weighs approximately 200
pounds, and will require at least one person at
each end to remove.
30. Illustration A14 Locate release lever A at the
rear or base assembly and apply downward
pressure. You should feel the latch disengage.
Illustration A13
Both latches must be disengaged prior to moving
base assembly to allow removal.
31. Tilt base assembly to approximately a 30
angle and pull forward. Slide base assembly
evenly to avoid binding.
32. Disconnect plug from control board and
ballast trays.
33. Remove both canopy harness assemblies
from the routing clips and lift out. Place ends of
harnesses in the service compartment.
34. Illustration A15 Remove rear pivot accent by
Illustration A14
removing the six 5 mm machine screws A along
the front of panel with a philips screwdriver.
35. Illustration A15 Apply upward pressure to the
front rail of canopy. Raise canopy high enough to
allow adequate clearance for removal. Slide
accent panel toward the front of unit and out of
rear grove. Pivot accent panel down.
36. Pull canopy harness cable through the accent
panel and place harnesses in service compart-
ment.
37. Apply upward pressure to the front rail of
canopy. Raise canopy high enough to allow
adequate clearance and remove pivot accent
Illustration A15
panel.
14