ergoline Genesis Classic 650 Owner's Manual page 20

Assembly Instructions
24. Illustration A36 Attach acrylic supports.
Raise acrylic panel assembly and attach support
retainer to the acrylic assembly with two 6 mm
philips self tapping screws. Repeat procedure for
opposing end.
25. Illustration A37 Open service access
compartment and locate Ergoline System Control
Unit at the left end of compartment. Remove
cover A. Connect plugs X 10 control cable and
plug X 9 contacts 1 and 2 sensor lead to control
board B. Reattach cover A.
26. Illustration A38 Remove the two 6 mm
attachment screws and hinge control unit assem-
bly down. This will expose the main power
connectors to the base and canopy assemblies.
Connect main power connectors 1.7, 1.10, 1.12.
Check all connections to insure proper seating.
27. Illustration A39 To attach front accent cover
place cover into required location noting that each
side is aligned properly with base side panels. It
should also be noted that the top edge of the
front lower accent panel is under the cover.
Secure cover with two 6mm self tapping screws.
Illustration A39
20
Illustration A36
Illustration A37
Illustration A38