Cleaning Or Replacing The Uv Lamps And Filter Panels In The Shoulder Tanner - ergoline PRESTIGE 1000 INTELLIGENT PERFORMANCE Operating Instructions Manual

Cleaning and maintenance
48/74
PRESTIGE 1200 / PRESTIGE 1400:
The facial tanner's UV low pressure lamps must be removed first so that the
UV high pressure lamps can be changed.
– Remove the lamps.
– Remove the ninth low pressure lamp in the canopy vertically so that you
can access the facial tanner's low pressure lamp starters.
Replacing lamps:
UV low pressure lamps: see page 43.
UV high pressure lamps and filter panels: see page 44.
Replacing starters: see page 44.
Changing the chip card: see page 42.
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Refit and retighten the screws. Refit the middle screw first and then the
outer screws.
5.12 Cleaning or replacing the UV lamps
and filter panels in the shoulder tan-
ner
– If an enclosed tanning tunnel is fitted: Remove the screws and then re-
move the tanning tunnel.