Lower Accent Lighting; Halogen Accent Lighting - ergoline Genesis Classic 650 Owner's Manual

24. Rotate top acrylic assembly into place and
secure by rotating the two (2) acrylic latches
counter clockwise.

Lower Accent Lighting

25. Open service compartment with service key.
Insert key into lock and turn clockwise 1/4 turn
and raise complete base assembly to its full
upright position. (Refer to Illustration L16)
26. Lower accent lighting is located along the
lower front rail. To remove lamp (A) turn 1/4 turn
and slide lamp from lampholder to disengage.
(Refer to Illustration L17)
27. Close service compartment.

Halogen Accent Lighting

28. Changing halogen accent lamps. Detach top
acrylic by applying pressure to the acrylic
assembly and rotate the acrylic latches clock-
wise. The acrylic assembly is attached with two
(2) retainers, one at the head end and one at the
foot end of the canopy. (Refer to Illustration L18)
29. After detaching the acrylic assembly, care-
fully lower the front down, resting the assembly
on the lower base of the unit.
30. Remove front five (5) tanning lamps. This will
expose inner service panel. Remove inner service
panel. Remove inner service panel by removing
screw (A) from the inside of the head and footend
of the unit.
31. Loosen screws (B) from inner panel. Pull red
accent from the grove and fold up. Remove
screws (B) at this time.
(Refer to Illustration L19)
32. To remove halogen accent lamp (B) pull lamp
and disengage from lampholder.
(Refer to Illustration L20)
33. To install halogen lamp align pins in lamp with
slots in lampholder and push lamp into place.
34. Repeat Steps 25 thru 31 in reverse order to
reassemble.
Relamping Instructions
Illustration L16
Illustration L17
Illustration L18
Illustration L19
Illustration L20
9