ergoline Genesis Classic 650 Owner's Manual page 19

Assembly Instructions
17. Illustration A32 Install the two 8 mm socket
head cap screws A into pivot hole B and tighten
securely.
18. Illustration A33 Install base unit support
springs. Lift base assembly to full upright position
and place the end of the gas support spring onto
the end of the ball stud coupler and apply pres-
sure allowing the spring to snap over coupler.
19. Illustration A33 Connect wiring harness
connections (1.1, 1.2, 1.3, 1.21, 1.30) from base
assembly to electronics. Wiring connections are
keyed and which should not allow improper
hookup. It is also important the connector be fully
seated into the receptacle to prevent arcing and
potential failure.
20. Illustration A34 Install lower accent panel.
Lift panel into service compartment and locate
panel in the required position and secure panel
with eight self tapping screws A.
21. Illustration A35 Place longitudinal cross
member into place over the mounting brackets
attached to the side leg panels and secure with
two 8 mm socket head cap screws A.
22. Illustration A35 To assemble lock mecha-
nism, place KL washer D over cable hook E and
engage cable hook E onto linkage F. Place
washer G over cable hook E and secure cable
with cotter pin C.
23. Close service compartment.
19
Illustration A32
Illustration A33
Illustration A34
Illustration A35