The following shows the inversion control for the X input of analog audio out 1
Audio
analogOut
Mixer
channel1x
inputInvert
Enable
disable
5.2.7.2.
Analog Audio Output Level Configuration
The analog outputs on the HD201x may be individually configured for different audio levels using the
DAC Gain Control parameter.
Audio
analogOut
dacGainControl
18 dBu
24 dBu
5.2.7.3.
Setting Analog Audio Output Soft Mute Control
The Force Soft Mute control allows the user to enable or disable a soft mute action for the channel
groups.
Audio
analogOut
forceSoftMute
On
Off
5.2.7.4.
Analog Audio Source Output Configuration
The HD201x analog outputs can operate in several different output modes. The analog outputs can be
configured to follow Embedder 1, Embedder 2, Embedder 3, Embedder 4 or follow the routing
programmed by the analog audio output mixer. The operating mode is chosen using the Output
Source control. Since there are only 8x analog outputs and each embedder has 16 channels, there are
two selections for each audio embedder. The first selection, allows the 8x analog audio outputs to
follow channels 1-8 of the relevant audio embedder. The second selection allows the 8x analog audio
outputs to follow channels 9-16 of the relevant audio embedder.
FRONT PANEL OPERATION
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
Select enable to invert the selected channel of audio and select
disable to pass through the selected audio channel.
Toggle to the appropriate level and select from one of the options:
18dBu
24dBu
When set to On, the soft mute will be forced.
When set to Off, the soft mute will not be forced.
Revision 0.1
TM
Page 5-53