Table of Contents
Advertisement
2.1.6.
HD/SD SDI Input and Outputs
HD/SD SDI OUT 1-4:
There are four BNCs on the rear panel, which support HD/SD serial digital outputs signals.
In the HD2014,
BNC 1 Out is internally connected to the output of PATH1.
BNC 2 Out is internally connected to the output of PATH2.
BNC 3 Out is internally connected to the output of PATH3.
BNC 4 Out is internally connected to the output of PATH4.
In the HD2011 and HD2012
BNC 1 Out is internally connected to the output of PATH1.
BNC 2 Out is internally connected to the output of PATH2.
BNC 3 Out is internally connected to the output of PATH1.
BNC 4 Out is internally connected to the output of PATH2.
HD/SD SDI IN 1-4:
There are four BNCs on the rear panel, which support HD/SDI/ASI serial digital input signals.
Processing of ASI input signals requires flex modules for MPEG/H264 video decoding.
2.1.7.
DVI Connections
DVI IN /PrPb/RB IN:
The female "DVI IN RB/PrPb IN" connector on the rear of the panel enables the user to connect both
DVI and component analog video signals to the HD201x series. Users may directly connect a standard
DVI-D cable to this connector to supply the HD201x series with a digital DVI signal. At the time of
writing, 1080p59.94/50 Hz and 720p59.94/50 Hz input signal formats are supported in the HD201x
series.
NOTE: At the time of this manual's writing, EDID is not currently supported. If a
DVI source REQUIRES EDID to operate, external EDID "dongles" like the DVI
DETECTIVE from Gefen can be used to ensure proper DVI operation.
To connect component analog video signals to the HD201x series, Evertz breakout cable #WPDVI-
DVIBNC5 (optional accessory) is required. Refer to the breakout cable diagram in Figure 2-5.
When the WPDVI-DVIBNC5 breakout cable is connected to the HD201x, DVI-D cables may be
connected to the female DVI connector of the break-out cable to supply digital DVI input signals. When
interfacing component analog video to the HD201x one must use the dedicated CBVS IN Y/G IN
BNC on the HD201x rear panel and the Red + Blue wires on the WPDVI-DVIBNC5 break-out cable.
The Y/G element of a component analog video signal is connected directly to BNC labelled CBVS IN
on the rear panel. The Pb/B element of a component analog signal should be connected to
Y/G IN
the BLUE wire on the break-out cable. The Pr/R element of a component analog signal should be
connected to the RED wire on the break-out cable. External H sync (if applicable) should be connected
to the GREY channel of the break-out cable. External V sync (if applicable) should be connected to the
BLACK channel of the break-out cable. At the time of this manual's writing, component analog video
inputs are not supported. Support for this feature will be included in the next firmware release.
INSTALLATION
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
Revision 0.1
TM
Page 2-7
Hide quick links:
Advertisement
Table of Contents
