evertz HD2014 User Manual page 4

INFORMATION TO USERS IN EUROPE
This equipment with the CE marking complies with both the EMC Directive (2004/108/EC) and the Low Voltage
Directive (2006/95/EC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European standards:
•
EN60065
•
EN55103-1
•
EN55103-2
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to the
European Union EMC directive. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
INFORMATION TO USERS IN THE U.S.A.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
Changes or Modifications not expressly approved by Evertz Microsystems Ltd. could void the user's authority to
operate the equipment.
Use of unshielded plugs or cables may cause radiation interference. Properly shielded interface
cables with the shield connected to the chassis ground of the device must
Evertz Microsystems Ltd
For Home or Office Use
Product Safety
Electromagnetic Interference Class A (Emission)
Electromagnetic Susceptibility (Immunity)
EN60065
EN55103-1: 1996
EN55103-2: 1996
FCC CLASS A DIGITAL DEVICE OR PERIPHERAL
Tested to comply with
FCC Standards
NOTE
Safety
Emission
Immunity
NOTE
WARNING
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
This device may cause harmful interference, and
This device must accept any interference received, including
interference that may cause undesired operation.
EN504192 2005
Waste electrical products should not
be disposed of with household waste.
Contact your Local Authority for
recycling advice