Figure 2-6: Two Connected Dvi Cables - evertz HD2014 User Manual

TM
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
RED
BLACK
GREEN
GREY
BLUE

Figure 2-6: Two Connected DVI Cables

DVI OUT 1 will carry the HD201x's DVI program output.
DVI OUT 2 will carry the HD201x's DVI internal multi-viewer output.
The Y/G element of a component analog signal must be connected directly to the BNC labelled CBVS
on the HD201x rear panel. The Pb/B elements of a component analog signal
OUT Y/G OUT
should be connected to the Blue wire on the break-out cable. The Pr/R element of a component analog
signal should be connected to the Red wire on the break-out cable. External H sync (if applicable)
should be connected to the GREY channel of the break-out cable. External V sync (if applicable)
should be connected to the BLACK channel of the break-out cable. At the time of this manual's writing,
component analog video outputs are not supported but will be added in the next firmware release for
the HD201x.
Revision 0.1
INSTALLATION Page 2-9