Selecting The Aspect Ratio Conversion Mode For The Processing Path - evertz HD2014 User Manual

4.1.4.

Selecting the Aspect Ratio Conversion Mode for the Processing Path

Once a particular processing path has been selected for control (per section 4.1.1) push the ARC
button on the front panel. The currently selected aspect ratio conversion mode will automatically appear
once the ARC button is pushed. To select a different aspect ratio conversion, use the shaft encoder on
the very right hand side of the front panel to select from the available list of aspect ratio conversion
modes. Once the desired aspect ratio conversion mode is shown on the front panel, select the new
conversion mode by depressing the shaft encoder. The text indicating the new conversion mode will
momentarily become brighter indicating that the shaft encoder has in fact been depressed and the new
conversion mode has been selected. The following table provides a list of the available conversions
fullRaster
User
sdPn143toTBCt169
ltBx139toTBCt169
ltBx149toTBCt169
stch139toTBCt169
stch149toTBCt169
stch169toTBCt169
stch139toSdPnl43
stch149toSdPnl43
stch169toSdPnl43
43to43SdPnlon169
43to139Stchon169
43to149Stchon169
43to169Stchon169
43to139Cropon169
43to149Cropon169
43to169Cropon169
169x169LtBxon43
169x149LtBxon43
169x139LtBxon43
169x43SdCuton43
169x43Sqzeon43
169TLBOn43To169
149TLBOn43TBC169
149TLBOn43SPn149
149TLB43To169St1
169LB43To169
149LB43ToTBC169m
149LB43ToSdPn149
149LB43To169St16
SP43To43
SP149To149LtBx43
SP149To43SdCt43
SP149To43Sqz43
FRONT PANEL OPERATION
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
Revision 0.1
TM
Page 4-3