Setting The Blanking Controls - Field 1; Setting The Blanking Controls - Field 2; Configuring The Analog Out Controls; Select The Output Format - evertz HD2014 User Manual

5.1.3.17. Setting the Blanking Controls – Field 2
The Blanking Controls for Field 2 enable the user to set what type of video processing will be applied to
lines 10 through 23 of the incoming video signal. Each line may be comb filtered, notch filtered, blanked
or bypassed directly to the Y channel output. For the sake of brevity, only the control for line 10 is
shown in this manual. Field 2, line 10 processing is determined using the VBI FLD 2 LINE 10 control.
At the time of writing, this feature is not implemented.
Video
AnalogIn
CompositeIn
vbiProcessing
FLD2
Line 10 to 23
Comb
Bypass-to-Y
Blank
5.1.4.

Configuring the Analog Out Controls

5.1.4.1.

Select the Output Format

The Output Format control enables the user to select the analog video output format. This control will
allow the user to configure the on-board video D/A converter to operate in either composite mode or
component mode. At the time of writing, the HD201x only supports composite analog video D/A.
Video
AnalogOut
outputSelect
---
5.1.4.2.

Output Force Black

The Output Force Black control allows the user to control whether the analog video output (whether
composite or component) is forced to black.
Video
AnalogOut
forceBlack
On
Off
FRONT PANEL OPERATION
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
Select one of the following options:
Comb – Comb filter content on line n.
Bypass-to-Y – Bypass content on line x to Y Channel output.
Blank – Blank content on line n.
Currently only composite format is available.
When On is selected the analog video outputs are forced to be black.
When Off is selected the analog video output will contain the active
video as generated by the HD201x and supplied to its video D to A
converter.
Revision 0.1
TM
Page 5-31