Setting The V Phase; Setting The Timing Reference; Viewing The Cdp 708 Demux - evertz HD2014 User Manual

5.1.2.44.

Setting the V Phase

With the V Phase Offset control, you can set the vertical timing of the output video with respect to the
reference. Setting this control to 0 keeps the output video frame aligned with the converter's reference
input or with the incoming video if reference is missing. For normal operation, the V Phase Offset
control for each converter should be set to 0. Increasing the value will delay the output video in one-
line increments of the output video standard. In order to advance the vertical timing of the output
video with respect to reference, set the control to the maximum total number of lines of the output
video minus the number of lines that you wish to advance the output video (e.g.: for 1080i/59.94 output
video the total number of lines is 1125, so to advance the output video 5 lines, set the value to 1120).
When increasing the V Phase Offset causes it to go beyond the limit of the frame buffer, the
V Phase Offset will wrap to the beginning of the frame buffer, resulting in a change of one frame of
throughput delay between the video input and the video output.
VIDEO
Processing
Converter
Path 1
Timing
hPhaseOffset
0 to 1124
5.1.2.45.

Setting the Timing Reference

Each individual converter is fed a copy of the reference that is supplied to the HD201x REF IN BNC.
To allow each converter to lock to this reference, the REFERENCE SELECT control should be set to
frame. To have the converters lock to the incoming video, select video.
VIDEO
Processing
Converter
Path 1
Timing
referenceSelect
Video
Frame
5.1.2.46.

Viewing the CDP 708 Demux

Each conversion path in the HD201x monitors that status of 708 captions on incoming video. This
control reports the status of the 708 packet demux process.
VIDEO
Processing
Converter
Path 1 to 4
Video Monitor
Cdp708Demux
FRONT PANEL OPERATION
HD2014, HD2012, HD2011 Video Passport
1RU Multi-Path Video Converter, Frame Synchronizer and Decoder
To set the V Phase Offset, enter a value between 0 and 1124 into the
V Phase field.
Video - Select Video to lock the output video to the input video. When
there is no input video, the output video will free run.
Frame - Select frame, to the lock to the reference applied to the
HD201x REF IN BNC.
This control displays information of the CDP 708 Demux
Revision 0.1
TM
Page 5-25