HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 28

Verifying the configuration
# Display BFD sessions on Switch A.
<SwitchA> display bfd session
Total Session Num: 1
IPv4 Session Working Under Ctrl Mode:
LD/RD
4/7
The output shows that the BFD session has been created.
# Display the static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 10. Then the link
over VLAN-interface 10 fails.
# Display static routes on Switch A.
<SwitchA> display ip routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination/Mask
120.1.1.0/24
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 1 1.
Up Session Num: 1
SourceAddr DestAddr
12.1.1.1 12.1.1.2
Proto Pre Cost
Static 60 0
Proto Pre Cost
Static 65 0
Init Mode: Active
State
Up
NextHop
12.1.1.2
NextHop
10.1.1.100
16
Holdtime Interface
2000ms Vlan10
Interface
Vlan10
Interface
Vlan11