Configuring An Ipv6 Policy; Creating An Ipv6 Node; Configuring Match Criteria For An Ipv6 Node; Configuring Actions For An Ipv6 Node - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Tasks at a glance
(Required.)
•
Configuring IPv6 local PBR
•
Configuring IPv6 interface PBR

Configuring an IPv6 policy

Creating an IPv6 node

Step
1. Enter system view.
2. Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.

Configuring match criteria for an IPv6 node

Step
1. Enter system view.
2. Enter IPv6 policy
node view.
3. Configure an ACL
match criterion.
NOTE:
An ACL match criterion uses the specified ACL to match packets regardless of the permit or deny action
and the time range of the ACL. If the specified ACL does not exist, no packet can match the criterion.

Configuring actions for an IPv6 node

Step
Enter system view.
1.
2. Enter IPv6 policy
node view.
Configuring IPv6 PBR:
Command
system-view
ipv6 policy-based-route policy-name [ deny |
permit ] node node-number
Command
system-view
ipv6 policy-based-route policy-name [ deny | permit ]
node node-number
if-match acl { acl6-number | name acl6-name }
Command
system-view
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
409
Remarks
N/A
By default, no IPv6 policy
node is created.
Remarks
N/A
N/A
By default, no ACL
match criterion is
configured.
Remarks
N/A
N/A