Configuring The Maximum Number Of Ecmp Routes - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

used. If the calculated cost is less than 1, the value of 1 is used. If no cost or bandwidth reference
value is configured for an interface, OSPF computes the interface cost based on the interface
bandwidth and default bandwidth reference value.
To configure an OSPF cost for an interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure an OSPF cost
for the interface.
To configure a bandwidth reference value:
Step
1. Enter system view.
2. Enter OSPF view.
3. Configure a bandwidth
reference value.

Configuring the maximum number of ECMP routes

Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Step
1. Enter system view.
2. Enter OSPF view.
3. Configure the maximum
number of ECMP routes.
Command
system-view
interface interface-type
interface-number
ospf cost value
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
bandwidth-reference value
Command
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
maximum load-balancing maximum
77
Remarks
N/A
N/A
By default, the OSPF cost is calculated
according to the interface bandwidth.
For a loopback interface, the OSPF cost
is 0 by default.
Remarks
N/A
N/A
The default setting is 100 Mbps.
Remarks
N/A
N/A
By default, the maximum
number of OSPF ECMP routes
equals the maximum number of
ECMP routes supported by the
system.
Use the max-ecmp-num
command to configure the
maximum number of ECMP
routes supported by the system.
For more information about the
max-ecmp-num command, see
Layer 3—IP Routing Command
Reference.