Controlling Rip Reception And Advertisement On Interfaces - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

If you configure RIP settings in interface view before enabling RIP, the settings do not take effect until RIP
is enabled. If a physical interface is attached to multiple networks, you cannot advertise these networks
in different RIP processes. You cannot enable multiple RIP processes on a physical interface.
Enabling RIP on a network
You can enable RIP on a network and specify a wildcard mask for the network. After that, only the
interface attached to the network runs RIP.
To enable RIP on a network:
Step
1. Enter system view.
2. Enable RIP and enter RIP view.
3. Enable RIP on a network.
Enabling RIP on an interface
Step
1. Enter system view.
2. Enable RIP and enter RIP view.
3. Return to system view.
4. Enter interface view.
5. Enable RIP on the interface.

Controlling RIP reception and advertisement on interfaces

Step
1. Enter system view.
2. Enter RIP view.
3. Disable an interface from
sending RIP messages.
4. Return to system view.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
network network-address
[ wildcard-mask ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
rip process-id enable
[ exclude-subip ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
silent-interface { interface-type
interface-number | all }
quit
25
Remarks
N/A
By default, RIP is disabled.
By default, RIP is disabled on a
network.
The network 0.0.0.0 command
can enable RIP on all interfaces in
a single process, but does not
apply to multiple RIP processes.
Remarks
N/A
By default, RIP is disabled.
N/A
N/A
By default, RIP is disabled on an
interface.
Remarks
N/A
N/A
By default, all RIP-enabled
interfaces can send RIP messages.
The disabled interface can still
receive RIP messages and respond
to unicast requests containing
unknown ports.
N/A