Ospfv3 Configuration Examples; Ospfv3 Stub Area Configuration Example - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Purpose
Restart an OSPFv3 process (available in
Release 2406P03 and later versions).
Restart OSPFv3 route redistribution
(available in Release 2406P03 and later
versions).
Clear OSPFv3 statistics (available in Release
2406P03 and later versions).

OSPFv3 configuration examples

OSPFv3 stub area configuration example

Network requirements
As shown in
Enable OSPFv3 on all switches.
•
• Split the AS into three areas.
Configure Switch B and Switch C as ABRs to forward routing information between areas.
•
Configure Area 2 as a stub area to reduce LSAs in the area without affecting route reachability.
•
Figure 88 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3:
# Configure Switch A: enable OSPFv3 and specify the router ID as 1.1.1.1.
<SwitchA> system-view
[SwitchA] ospfv3
[SwitchA-ospfv3-1] router-id 1.1.1.1
[SwitchA-ospfv3-1] quit
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] ospfv3 1 area 1
[SwitchA-Vlan-interface300] quit
Figure 88:
Command
reset ospfv3 [ process-id ] process [ graceful-restart ]
reset ospfv3 [ process-id ] redistribution
reset ospfv3 [ process-id ] statistics
370