Configuring Rip To Advertise A Summary Route - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

1.0.0.0/8, auto-summary
The output shows that only one RIP route reaches network 1.1.5.0/24, with the next hop as Switch
B (1.1.1.2) and a cost of 2.

Configuring RIP to advertise a summary route

Network requirements
As shown in
RIP. Configure RIP to redistribute OSPF routes on Switch C so Switch D can learn routes destined for
networks 10.1.1.0/24, 10.2.1.0/24, 10.5.1.0/24, and 10.6.1.0/24.
To reduce the routing table size of Switch D, configure route summarization on Switch C to advertise only
the summary route 10.0.0.0/8 to Switch D.
Figure 10 Network diagram
Vlan-int400
11.4.1.2/24
Switch D
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic OSPF:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.5.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 10.2.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ospf
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 10.6.1.0 0.0.0.255
1.1.1.0/24, cost 0, nexthop 1.1.1.1, RIP-interface
1.1.2.0/24, cost 0, nexthop 1.1.2.1, RIP-interface
1.1.3.0/24, cost 1, nexthop 1.1.1.2
1.1.4.0/24, cost 2, nexthop 1.1.1.2
1.1.5.0/24, cost 2, nexthop 1.1.1.2
Figure 10, Switch A and Switch B run OSPF, Switch D runs RIP, and Switch C runs OSPF and
Vlan-int200
10.1.1.2/24
Vlan-int300
11.3.1.1/24
Switch C
RIP
Vlan-int300
11.3.1.2/24
Vlan-int500
Vlan-int200
10.6.1.2/24
10.1.1.1/24
Switch B
Vlan-int600
Vlan-int100
10.5.1.2/24
10.2.1.2/24
Vlan-int100
10.2.1.1/24
Switch A
45
OSPF