Configuring Received/Redistributed Route Filtering; Configuring A Preference For Rip - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Step
3. Enable RIP to advertise a
default route.
4. Return to system view.
5. Enter interface view.
6. Configure the RIP interface to
advertise a default route.
NOTE:
The router enabled to advertise a default route does not accept default routes from RIP neighbors.

Configuring received/redistributed route filtering

Perform this task to filter received and redistributed routes by using an IP prefix list. You can also configure
RIP to receive routes only from a specified neighbor.
To configure route filtering:
Step
1. Enter system view.
2. Enter RIP view.
3. Configure the filtering of
received routes.
4. Configure the filtering of
redistributed routes.

Configuring a preference for RIP

If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest priority
is selected as the optimal route. Perform this task to assign a preference to RIP. The smaller the preference
value, the higher the priority.
Command
default-route { only | originate }
[ cost cost ]
quit
interface interface-type
interface-number
rip default-route { { only |
originate } [ cost cost ] |
no-originate }
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
filter-policy { acl-number | gateway
prefix-list-name | prefix-list
prefix-list-name [ gateway
prefix-list-name ] } import
[ interface-type interface-number ]
filter-policy { acl-number | prefix-list
prefix-list-name } export [ protocol
[ process-id ] | interface-type
interface-number ]
29
Remarks
By default, RIP does not advertise a
default route.
N/A
N/A
By default, a RIP interface can
advertise a default route if the RIP
process is enabled to advertise a
default route.
Remarks
N/A
N/A
By default, the filtering of
received routes is not configured.
This command filters received
routes. Filtered routes are not
installed into the routing table or
advertised to neighbors.
By default, the filtering of
redistributed routes is not
configured.
This command filters redistributed
routes, including routes
redistributed with the
import-route command.