Task
Re-enable OSPF route
redistribution.
OSPF configuration examples
These configuration examples only cover commands for OSPF configuration.
Basic OSPF configuration example
Network requirements
Enable OSPF on all switches, and split the AS into three areas.
•
•
Configure Switch A and Switch B as ABRs.
Figure 22 Network diagram
Switch A
Vlan-int200
10.2.1.1/24
Area 1
Vlan-int200
10.2.1.2/24
Switch C
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Enable OSPF:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] router id 10.2.1.1
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] area 1
[SwitchA-ospf-1-area-0.0.0.1] network 10.2.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.1] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] router id 10.3.1.1
[SwitchB] ospf
Area 0
Vlan-int100
10.1.1.1/24
Vlan-int100
10.1.1.2/24
Vlan-int300
Vlan-int300
10.4.1.1/24
10.5.1.1/24
Command
reset ospf [ process-id ] redistribution
Switch B
Vlan-int200
10.3.1.1/24
Vlan-int200
Area 2
10.3.1.2/24
Switch D
97