HP 6125XLG Layer 3 - Ip Routing Configuration Manual page 387

Figure 89 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic OSPFv3 (see
3. Configure Area 1 as an NSSA area:
# Configure Switch A.
[SwitchA] ospfv3
[SwitchA-ospfv3-1] area 1
[SwitchA-ospfv3-1-area-0.0.0.1] nssa
[SwitchA-ospfv3-1-area-0.0.0.1] quit
[SwitchA-ospfv3-1] quit
# Configure Switch B.
[SwitchB] ospfv3
[SwitchB-ospfv3-1] area 1
[SwitchB-ospfv3-1-area-0.0.0.1] nssa
[SwitchB-ospfv3-1-area-0.0.0.1] quit
[SwitchB-ospfv3-1] quit
# Display OSPFv3 routing information on Switch A.
[SwitchA] display ospfv3 1 routing
-------------------------------------------------------------------------
I - Intra area route,
IA - Inter area route,
* - Selected route
*Destination: 2001::/64
Type
NextHop
AdvRouter
Preference : 10
*Destination: 2001:1::/64
Type
"OSPFv3 stub area configuration
OSPFv3 Process 1 with Router ID 1.1.1.1
E1 - Type 1 external route,
E2 - Type 2 external route,
: IA
: FE80::20C:29FF:FE74:59C6
: 2.2.2.2
: I
375
example").
N1 - Type 1 NSSA route
N2 - Type 2 NSSA route
Cost : 2
Interface: Vlan200
Area : 0.0.0.1
Cost : 1