Configuring A Rip Version; Configuring Rip Route Control - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Step
5. Enter interface view.
6. Enable an interface to receive
RIP messages.
7. Enable an interface to send
RIP messages.

Configuring a RIP version

You can configure a global RIP version in RIP view or an interface-specific RIP version in interface view.
An interface preferentially uses the interface-specific RIP version. If no interface-specific version is
specified, the interface uses the global RIP version. If neither global nor interface-specific RIP version is
configured, the interface sends RIPv1 broadcasts, and can receive RIPv1 broadcasts and unicasts, and
RIPv2 broadcasts, multicasts, and unicasts.
To configure a RIP version:
Step
1. Enter system view.
2. Enter RIP view.
3. Specify a global RIP version.
4. Return to system view.
5. Enter interface view.
6. Specify a RIP version for the
interface.

Configuring RIP route control

Before you configure RIP route control, complete the following tasks:
Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
•
Configure basic RIP.
•
Command
interface interface-type
interface-number
rip input
rip output
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
version { 1 | 2 }
quit
interface interface-type
interface-number
rip version { 1 | 2 [ broadcast |
multicast ] }
26
Remarks
N/A
By default, a RIP-enabled interface
can receive RIP messages.
By default, a RIP-enabled interface
can send RIP messages.
Remarks
N/A
N/A
By default, no global version is
specified, and an interface sends
RIPv1 broadcasts, and can receive
RIPv1 broadcasts and unicasts,
and RIPv2 broadcasts, multicasts,
and unicasts.
N/A
N/A
By default, no interface-specific RIP
version is specified, and the
interface sends RIPv1 broadcasts,
and can receive RIPv1 broadcasts
and unicasts, and RIPv2
broadcasts, multicasts, and
unicasts.