Displaying And Maintaining The Routing Policy; Routing Policy Configuration Examples; Applying A Routing Policy To Ipv4 Route Redistribution - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

apply cost clauses with the + or - keyword, the apply community clauses with the additive keyword,
and the apply extcommunity clauses with the additive keyword), all the apply clauses configured
on the matching nodes take effect.
• If you configure the apply community clause for multiple nodes that are combined by the continue
clause, the apply comm-list delete clause configured on the current node cannot delete the
community attributes set by preceding nodes.
To configure a continue clause:
Step
1. Enter system view.
2. Enter routing policy node view.
Specify the next node to be
3.
matched.

Displaying and maintaining the routing policy

Execute display commands in any view and reset commands in user view.
Task
Display BGP AS path list information.
Display BGP community list information.
Display BGP extended community list
information.
Display IPv4 prefix list statistics.
Display IPv6 prefix list statistics.
Display routing policy information.
Clear IPv4 prefix list statistics.
Clear IPv6 prefix list statistics.

Routing policy configuration examples

Applying a routing policy to IPv4 route redistribution

Network Requirements
As shown in
Switch C by using IS-IS.
Figure 101, Switch B exchanges routing information with Switch A by using OSPF and with
Command
system-view
route-policy route-policy-name
{ deny | permit } node node-number
continue [ node-number ]
Command
display ip as-path [ as-path-number ]
display ip community-list [ basic-community-list-number |
adv-community-list-number | name comm-list-name ]
display ip extcommunity-list [ ext-comm-list-number ]
display ip prefix-list [ name prefix-list-name ]
display ipv6 prefix-list [ name prefix-list-name ]
display route-policy [ name route-policy-name ]
reset ip prefix-list [ prefix-list-name ]
reset ipv6 prefix-list [ prefix-list-name ]
422
Remarks
N/A
N/A
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.