Configuring Rip Network Management; Configuring The Rip Packet Sending Rate - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

If the specified neighbor is not directly connected, disable source address check on incoming
•
updates.
To specify a RIP neighbor:
Step
1. Enter system view.
2. Enter RIP view.
3. Specify a RIP neighbor.
4. Disable source IP
address check on
inbound RIP updates

Configuring RIP network management

You can use network management software to manage the RIP process to which MIB is bound.
To configure RIP network management:
Step
1. Enter system view.
2. Bind MIB to a RIP
process.

Configuring the RIP packet sending rate

Perform this task to specify the interval for sending RIP packets and the maximum number of RIP packets
that can be sent at each interval. This feature can avoid excessive RIP packets from affecting system
performance and consuming too much bandwidth.
To configure the RIP packet sending rate:
Step
1. Enter system view.
2. Enter RIP view.
3. Specify the interval for
sending RIP packets and the
maximum number of RIP
packets that can be sent at
each interval.
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
peer ip-address
undo validate-source-address
Command
system-view
rip mib-binding process-id
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
output-delay time count count
34
Remarks
N/A
N/A
By default, RIP does not
unicast updates to any
peer.
By default, source IP
address check on inbound
RIP updates is enabled.
Remarks
N/A
By default, MIB is bound to the RIP
process with the smallest process
ID.
Remarks
N/A
N/A
By default, an interface sends up to
three RIP packets every 20
milliseconds.