Bfd For Static Routes Configuration Example (Indirect Next Hop) - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Blade switch
Hide thumbs Also See for 6125XLG:
Table of Contents

Advertisement

BFD for static routes configuration example (indirect next hop)

Network requirements
In
Figure
4, Switch A has a route to interface Loopback 1 (2.2.2.9/32) on Switch B, with the output
interface VLAN-interface 10. Switch B has a route to interface Loopback 1 (1.1.1.9/32) on Switch A, with
the output interface VLAN-interface 12. Switch D has a route to 1.1.1.9/32, with the output interface
VLAN-interface 10, and a route to 2.2.2.9/32, with the output interface VLAN-interface 12.
Configure a static route to subnet 120.1.1.0/24 on Switch A, and configure a static route to subnet
121.1.1.0/24 on Switch B. Enable BFD for both routes. Configure a static route to subnet 120.1.1.0/24 and
a static route to subnet 121.1.1.0/24 on both Switch C and Switch D. When the link between Switch A and
Switch B through Switch D fails, BFD can detect the failure immediately and inform Switch A and Switch
B to communicate through Switch C.
Figure 4 Network diagram
Device
Switch A
Switch C
Configuration procedure
1.
Configure IP addresses for interfaces. (Details not shown.)
2.
Configure static routes and BFD:
# Configure static routes on Switch A and enable BFD control mode for the static route that
traverses Switch D.
<SwitchA> system-view
[SwitchA] bfd multi-hop min-transmit-interval 500
[SwitchA] bfd multi-hop min-receive-interval 500
[SwitchA] bfd multi-hop detect-multiplier 9
[SwitchA] ip route-static 120.1.1.0 24 2.2.2.9 bfd control-packet bfd-source 1.1.1.9
[SwitchA] ip route-static 120.1.1.0 24 vlan-interface 11 10.1.1.100 preference 65
[SwitchA] quit
# Configure static routes on Switch B and enable BFD control mode for the static route that
traverses Switch D.
<SwitchB> system-view
Interface
IP address
Vlan-int10
12.1.1.1/24
Vlan-int11
10.1.1.102/24
Loop1
1.1.1.9/32
Vlan-int11
10.1.1.100/24
Vlan-int13
13.1.1.2/24
Device
Interface
Switch B
Vlan-int12
Vlan-int13
Loop1
Switch D
Vlan-int10
Vlan-int12
17
IP address
11.1.1.1/24
13.1.1.1/24
2.2.2.9/32
12.1.1.2/24
11.1.1.2/24

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5920 series5900 series

Table of Contents