Setting The Maximum Length Of Rip Packets; Configuring Rip Gr - HP 6125XLG Layer 3 - Ip Routing Configuration Manual

Setting the maximum length of RIP packets

NOTE:
The supported maximum length of RIP packets varies by vendor. Use this feature with caution to avoid
compatibility issues.
The packet length of RIP packets determines how many routes can be carried in a RIP packet. Set the
maximum length of RIP packets to make good use of link bandwidth.
When authentication is enabled, follow these guidelines to ensure packet forwarding:
For simple authentication, the maximum length of RIP packets must be no less than 52 bytes.
•
For MD5 authentication (with packet format defined in RFC 2453), the maximum length of RIP
•
packets must be no less than 56 bytes.
For MD5 authentication (with packet format defined in RFC 2082), the maximum length of RIP
•
packets must be no less than 72 bytes.
To set the maximum length of RIP packets:
Step
1. Enter system view.
2. Enter interface view.
3. Set the maximum length of RIP
packets.

Configuring RIP GR

GR ensures forwarding continuity when a routing protocol restarts or an active/standby switchover
occurs.
Two routers are required to complete a GR process. The following are router roles in a GR process.
GR restarter—Graceful restarting router. It must have GR capability.
•
GR helper—A neighbor of the GR restarter. It helps the GR restarter to complete the GR process.
•
After RIP restarts on a router, the router must learn RIP routes again and update its FIB table, which causes
network disconnections and route reconvergence.
With the GR feature, the restarting router (known as the "GR restarter") can notify the event to its GR
capable neighbors. GR capable neighbors (known as "GR helpers") keep their adjacencies with the
router within a GR interval. During this process, the FIB table of the router does not change. After the
restart, the router contacts its neighbors to retrieve its FIB.
By default, a RIP-enabled device acts as the GR helper. Perform this task on the GR restarter.
To configure GR on the GR restarter:
Step
1. Enter system view.
Command
system-view
interface interface-type
interface-number
rip max-packet-length value
Command
system-view
35
Remarks
N/A
N/A
By default, the maximum length of
RIP packets is 512 bytes.
Remarks
N/A