Filling And Adjusting The Feeder Sealer; How To Fill The Sealer Bottle; How To Adjust The Sealing Water Flow - Neopost IS-480 User Manual

Filling and Adjusting the Feeder Sealer

10.2 Filling and Adjusting the Feeder
Filling the Sealer Bottle
The Automatic Feeder uses water for sealing envelopes.
If the system is out of water, the mailing process continues but the envelopes will not
sealed properly.

How to Fill the Sealer Bottle

How to Fill the
Sealer Bottle
10
Adjusting the Sealing Water Flow
Before you adjust the sealing water flow, make sure that the brushes and sponge are
clean (see

How to Adjust the Sealing Water Flow

How to Adjust
the Sealing
Water Flow
216
Sealer
To add water (or sealing solution) to the bottle:
1
Remove the bottle from its base and turn it over.
2
Unscrew the cap and fill
the bottle with water up
to the limit marks.
3
Screw the cap back and
put the bottle back into
place.
How to Clean the Brushes and Sponge (Sealer)
To adjust the sealing water flow:
1
Set the water flow using
the back lever.
When standing in front
of the feeder:
- Push the lever towards
the left-hand side to in-
crease the water level.
- Push the lever towards
the right-hand side to de-
crease the water level.
p.218).