Programming For Roughing And Finishing (Example 4) - Siemens SINUMERIK User Manual

13.5

Programming for roughing and finishing (Example 4)

Workpiece drawing (unit: mm)
Blank data
Blank material: aluminum bar
Blank diameter: 45 mm
Diameter of the bottom hole: 18 mm
Blank length: 150 mm (machining limit along the Z axis: Z-95; three-jaw chuck clamping length: 40 mm)
Required tools
Tool type
Turning tool for boring
Internal threading tool
Note
When programming in ISO mode, you need to set the H numbers of T1 and T2 to 1 and 2 respectively;
•
Cut the workpiece manually after machining is over.
•
Operating sequence for programming in Siemens mode
1.
2.
3.
236
Tool number
DIN ISO
T1D1 T0101
T2D1 T0202
Select the program management operating area.
Press this softkey to enter the system directory for storing part programs.
Press this softkey and enter the name of the new program.
Roughing
Speed Feedrate
S1000 F0.2
S1000 F0.2
Programming and Operating Manual (Turning)
Finishing
Speed Feedrate
S2000 F0.1
S600 F1.5
01/2017