Siemens SINUMERIK User Manual page 14

Enables/disables the tailstock to hold the workpiece tightly (active only when the machine is in "JOG" mode)
Indicator on: The tailstock moves towards the workpiece until it holds the workpiece tightly.
Indicator off: The tailstock retracts from the workpiece to its original position.
Reserved keys.
K1 to K5,
K7 to K12
You can define the functions of these keys in PLC Programming Tool. For more information, see the
SINUMERIK 808D/SINUMERIK 808D ADVANCED Commissioning Manual.
Pre-defined labeling strips for keys of the MCP
The MCP package includes two sets (six pieces each) of pre-defined labeling strips. One set (
turning variant of the control system and pre-inserted on the back of the MCP. The other set (
milling variant of the control system.
Note
For the horizontal MCP variant with a reserved slot for the handwheel, no pre-defined labeling strip is provided.
If your control system is a milling variant of the control system, replace the pre-inserted labeling strips with the milling-
specific ones.
If the pre-defined labeling strips cannot meet your needs, proceed as follows to make customized labeling strips by using the
A4-sized blank plastic sheet in the MCP package:
1. Open the "Symbols for MCP customized key_808D" file in one of the following folders on the Toolbox DVD for the control
system on your computer:
– \examples\SINUMERIK_808D\MCP (for PPU141.2)
– \examples\SINUMERIK_808D_ADVANCED\MCP (for PPU160.2 and PPU161.3)
2. Copy the desired symbols of keys from the file and then paste them to the desired locations for key labels in the
"Strip_template_808D" file.
3. Print the final labeling strip template file on the blank plastic sheet.
4. Replace the pre-inserted labeling strips from the MCP with the customized ones.
Note
The MCP information described in this manual is valid for the SINUMERIK 808D MCP.
14
①
as shown below) is for the
②
as shown below) is for the
Programming and Operating Manual (Turning)
01/2017