Siemens SINUMERIK User Manual page 238

238
9. Press this softkey to return to the window for CYCLE95 and enter the desired parameters
as follows:
10. Press this softkey to confirm your input and open the cycle programming window.
11. Enter the following program block below the program line for CYCLE95:
M3 S1000
12. Press this softkey to return to the program editor window.
13. Move the cursor to "C" in the line for CYCLE95 with the cursor keys and press this soft-
key to insert a marker.
14. Use the cursor keys to select the entire program block for CYCLE95. Press this softkey to
copy the selection to the buffer memory.
15. Place the cursor on the end-of-block character after "M3 S1000" with cursor keys and press
this key on the MCP to enter a new line.
16. Paste the content of the buffer memory into the new line.
17. Press this softkey to open the window for CYCLE95 again. Move the cursor to the input field
of "VARI".
18. Press this key to change the value to "7".
19. Press this softkey to accept the change and continue to enter the following program blocks:
G0 X0 Z150
M05
M00
T2 D1
M3 S600
20. Open the vertical softkey bar for available turning cycles.
21. Open the vertical softkey bar for thread cutting cycles.
Programming and Operating Manual (Turning)
01/2017