Error Messages And Error Handling; General Information; Error Handling In The Cycles; Overview Of Cycle Alarms - Siemens SINUMERIK User Manual

12.6

Error messages and error handling

12.6.1

General Information

If error conditions are detected in the cycles, an alarm is generated and the execution of the cycle is aborted.
Furthermore, the cycles display their messages in the message line of the control system. These messages will not interrupt
the program execution.
The errors with their reactions and the messages in the message line of the control system are described in conjunction with
the individual cycles.
12.6.2

Error handling in the cycles

Alarms with numbers between 61000 and 62999 generated in the cycles. This range of numbers, in turn, is divided again
with regard to alarm responses and cancel criteria.
The error text that is displayed together with the alarm number gives you more detailed information on the error cause.
Alarm number
61000 ... 61999
62000 ... 62999
12.6.3

Overview of cycle alarms

The error numbers are classified as follows:
6
● X=0 General cycle alarms
● X=1 Alarms generated by the drilling/drilling pattern/milling cycles
● X=6 Alarms generated by the turning cycles
12.6.4

Messages in the cycles

The cycles display their messages in the message line of the control system. These messages will not interrupt the program
execution.
Messages provide information with regard to a certain behavior of the cycles and with regard to the progress of machining
and are usually kept beyond a machining step or until the end of the cycle. An example of messages is as follows:
"Depth: according to the value for the relative depth" from all drilling cycles.
Programming and Operating Manual (Turning)
01/2017
Clearing criterion
NC_RESET
Clear key
_ X
Alarm Response
Block preparation in the NC is aborted
The block preparation is interrupted;
the cycle can be continued the follow-
ing key on the MCP after the alarm has
been cleared:
_ _
215