Siemens SINUMERIK User Manual page 298

Address Significance
Timer for runtime:
$A..._..._ $AN_SETUP_TIME
TIME $AN_POWERON_TIM
E
$AC_OPERATING_TI
ME
$AC_CYCLE_TIME
$AC_CUTTING_TIME
Workpiece counter:
$AC_..._ $AC_TOTAL_PARTS
PARTS $AC_REQUIRED
_PARTS
$AC_ACTUAL_PARTS
$AC_SPECIAL_PART
S
$AC_ Number of active spin-
MSNUM dles
$P_ Number of pro-
MSNUM grammed spindles
$P_NUM_ Number of configured
SPINDLES spindles
$AA_S[n] Actual speed of spindle
n
$P_S[n] Last programmed
speed of spindle n
$AC_ Current direction of
SDIR[n] rotation of spindle n
$P_ Last programmed
SDIR[n] direction of rotation of
spindle n
$P_ Number of the active
TOOLNO tool T
$P_TOOL Active D number of the
active tool
MSG () Signal
OFFN Dimension specifica-
tion
RND Rounding
298
Value assign- Information
ments
0.0 ... 10+300 System variable:
Time since the control system
min (value read-
has last booted
only)
Time since the control system
min (value read-
has last booted normally
only)
Total runtime of all NC programs
s
Runtime of the NC program (only
of the selected program)
s
Tool action time
s
0 ... 999 999 999, System variable:
integer Total actual count
Set number of workpiece
Current actual count
Count of workpieces - specified
by the user
read-only
read-only
read-only
Spindle number n =1
read-only
Spindle number n =1
read-only
Spindle number n =1
read-only
Spindle number n =1
read-only
- read-only
- read-only
max. 65 charac- Message text in inverted com-
ters mas
- Only effective with the tool radius
compensation G41, G42 active
0.010 ... 99 Inserts a rounding with the speci-
999.999 fied radius value tangentially
between two contour blocks
Programming
N10 IF
$AC_CYCLE_TIME==50.
5 ....
N10 IF
$AC_ACTUAL_PARTS==
15 ....
N10 IF $P_TOOLNO==12
GOTOF ....
N10 IF $P_TOOL==1
GOTOF ....
MSG("MESSAGE TEXT")
; separate block
...
N150 MSG() ; Clear pre-
vious message
N10 OFFN=12.4
N10 X... Z.... RND=...
N11 X... Z...
Programming and Operating Manual (Turning)
01/2017