Siemens SINUMERIK User Manual page 292

Address Significance
H H function
H0=
to
H9999=
I Interpolation parame-
ters
K Interpolation parame-
ters
I1= Intermediate point for
circular interpolation
K1= Intermediate point for
circular interpolation
L Subroutine; name and
call
M Additional function
M0 Programmed stop
M1 Optional stop
M2 End of main program with return to begin-
ning of program
M30 End of program (as M2)
M17 End of subroutine
M3 CW rotation of spindle
M4 CCW rotation of spindle
292
Value assign- Information
ments
± 0.0000001 ... Value transfer to the PLC;
9999 9999 significance defined by the ma-
(8 decimal places) chine manufacturer
or specified as an
exponent:
± (10-300 ...
10+300 )
±0.001 ... 99 Belongs to the X axis; meaning
999.999 dependent on G2,G3 ->circle
Thread: center or G33, G34, G35 G331,
0.001 ... 2000.000 G332 -> thread lead
±0.001 ... 99 Belongs to the Z axis; others, as
999.999 with I
Thread:
0.001 ... 2000.000
±0.001 ... 99 Belongs to the X axis; specifica-
999.999 tion for circular interpolation with
CIP
±0.001 ... 99 Belongs to the Z axis; specifica-
999.999 tion for circular interpolation with
CIP
7 decimals; Instead of a free name, it is also
integer only, no possible to select L1
sign ...L9999999;
this also calls the subroutine
(UP) in a separate block,
Please note: L0001 is not always
equal to L1.
The name "LL6" is reserved for
the tool change subroutine.
0 ... 99 For example, for initiating switch-
only integer, no ing actions, such as "coolant
sign ON", maximum five M functions
per block.
The machining is stopped at the
end of a block containing M0; to
continue, press the following
key:
As with M0, but the stop is only
performed if a special signal
(Program control: "M01") is pre-
sent.
Can be found in the last block of
the processing sequence
Can be found in the last block of
the processing sequence
Can be found in the last block of
the processing sequence
Programming
H0=... H9999=...
e.g.: H7=23.456
See G2, G3 and G33,
G34, G35
See G2, G3 and G33,
G34, G35
See CIP
See CIP
L.... ;separate block
M...
Programming and Operating Manual (Turning)
01/2017