Siemens SINUMERIK User Manual page 282

282
5. Define a start point with the following parameters and press this softkey to confirm.
Programming mode: DIAMOF
•
Z: 0
•
X: 0
•
6. Press this softkey to select a contour element of straight vertical line.
7. Enter the parameters for this element and press this softkey to confirm.
X: 20 inc.
•
CHR: 5*1.1223 = 5.6115
•
8. Press this softkey to select a contour element of straight horizontal line.
9. Enter the parameters for this element and press this softkey to confirm.
Z: -25 inc.
•
10. Press this softkey to select a contour element of straight line in any direction.
11. Enter the parameters for this element and press this softkey to confirm.
X: 10 inc.
•
Z: -30 inc.
•
12. Press this softkey to select a contour element of straight horizontal line.
13. Enter the parameters for this element and press this softkey to confirm.
Z: -8 inc.
•
RND: 2
•
14. Press this softkey to select a contour element of circular arc.
15. Enter the parameters for this element and press this softkey to select the desired contour
characteristics.
Direction of rotation: counter-clockwise
•
R: 20
•
X: 20 inc
•
Z: -20 inc
•
16. Press this softkey to confirm.
17. Press this softkey to select a contour element of straight horizontal line.
18. Enter the parameters for this element and press this softkey to confirm.
Z: -20 inc.
•
RND: 2
•
Programming and Operating Manual (Turning)
01/2017