Offset Operating Area - Siemens SINUMERIK User Manual

⑥
Opens the program simulation window to check the programming results before machining
⑦
Recompiles the current cycle or contour selected with cursor by reopening the previous programming window
⑧
Executes the current program
⑨
Automatically assigns block numbers (Nxx) to all blocks
⑩
Opens the block search dialog box
⑪
Inserts a marker at the cursor position for copying/deleting the program blocks selected with the cursor
⑫
Copies the selected program blocks to the buffer memory
⑬
Pastes the copied program blocks at the current cursor position
A.1.3

Offset operating area

Softkey functions
Pressing this key on the PPU allows you to open the following window:
Softkey Function
①
Displays and modifies the tool offsets
②
Displays and modifies the tool wear data
③
Displays and modifies the workpiece offsets
④
Displays and modifies the R variables
⑤
Configures and displays lists of setting data
⑥
Displays the defined user data
⑦
Measures the tool manually (active only in "JOG"
mode and when the cursor is on the input field for
tool length)
244
See also
"Creating a tool (Page 20)"
•
"Creating/changing a cutting edge (Page 22)"
•
"Entering the tool wear offsets (Page 48)"
"Entering/modifying workpiece offsets (Page 54)"
"Setting R parameters (Page 58)"
"Entering/modifying the setting data (Page 55)"
"Setting user data (Page 58)"
"Measuring the tool manually (with the Y axis)
(Page 28)"
Programming and Operating Manual (Turning)
01/2017