284
4.
Press this softkey to open the contour editor.
5.
Define a start point with the following parameters and press this softkey to confirm.
Programming mode: DIAMON
•
Z: 0
•
X: 0
•
6.
Press this softkey to select a contour element of straight vertical line.
7.
Enter the parameters for this element and press this softkey to confirm.
X: 48 abs.
•
CHR: 3
•
8.
Press this softkey to select a contour element of straight horizontal line.
9.
Enter the parameters for this element and press this softkey to confirm.
RND: 4
•
10.
Press this softkey to select a contour element of circular arc.
11.
Enter the parameters for this element and press this softkey to select the desired contour
characteristics.
R: 23
•
X: 60 abs.
•
Z: -20 abs.
•
12.
Press this softkey to confirm.
13.
Press this softkey to select a contour element of straight horizontal line.
14.
Enter the parameters for this element and press this softkey to confirm.
Z: -75 abs.
•
RND: 6
•
15.
Press this softkey to select a contour element of straight line in any direction.
16.
Enter the parameters for this element and press this softkey to confirm.
X: 90 abs.
•
Z: -80 abs.
•
RND: 4
•
17.
Press this softkey to select a contour element of straight horizontal line.
18.
Enter the parameters for this element and press this softkey to confirm.
Z: -100 abs.
•
Programming and Operating Manual (Turning)
01/2017