Siemens SINUMERIK User Manual page 290

Address Significance
G332 Thread interpolation - retraction
G4 Dwell time
G74 Reference point approach
G75 Fixed point approach
TRANS Translation, programmable
SCALE Programmable scaling factor
ROT Rotation, programmable
MIRROR Programmable mirroring
ATRANS Additive translation, programming
ASCALE Additive programmable scaling factor
AROT Additive programmable rotation
AMIRROR Additive programmable mirroring
G17 X/Y plane (when center-drilling,
TRANSMIT milling required))
G18 * Z/X plane (standard turning)
G19 Y/Z plane
G40 * Tool radius compensation OFF
G41 Tool radius compensation; along the mov-
ing direction of the tool, always left of con-
tour
G42 Tool radius compensation; along the mov-
ing direction of the tool, always right of
contour
G500 * Settable work offset OFF
G54 1. Settable work offset
290
Value assign- Information
ments
2: Special motions, dwell time,
non-modal
3: Write memory, non-modal
6: Plane selection
7: Tool radius compensation,
modally effective
8: Settable work offset, modally
effective
Programming
G332 Z... K... ;tapping
without compensating
chuck, e.g. in Z axis,
retraction motion
; sign of lead as for G331
G4 F...;separate block, F:
Time in seconds
or
G4 S.... ;separate block,
S: in spindle revolutions
G74 X=0 Z=0 ;separate
block,
(machine axis identifier!)
G75 X=0 Z=0 ;separate
block,
(machine axis identifier!)
TRANS X... Z... ;separate
block
SCALE X... Z... ; scaling
factor in the direction of
the specified axis, sepa-
rate block
ROT RPL=... ;rotation in
the current plane G17 to
G19, separate block
MIRROR X0 ; mirror the
coordinate axis, separate
block
ATRANS X... Z... ; sepa-
rate block
ASCALE X... Z... ; scaling
factor in the direction of
the specified axis, sepa-
rate block
AROT RPL=... ; rotation
in the current plane G17
to G19, separate block
AMIRROR X0 ;mirror the
coordinate axis, separate
block
Programming and Operating Manual (Turning)
01/2017