Siemens SINUMERIK User Manual page 300

Address Significance
TRACYL Milling of the peripheral
surface
TRANSMIT Milling of the face end
TRAFOOF Disable TRANSMIT,
TRACYL
Trademarks
All names identified by ® are registered trademarks of Siemens AG. The remaining trademarks in this publication may be trademarks whose
use by third parties for their own purposes could violate the rights of the owner.
Disclaimer of Liability
We have reviewed the contents of this publication to ensure consistency with the hardware and software described. Since variance cannot
be precluded entirely, we cannot guarantee full consistency. However, the information in this publication is reviewed regularly and any
necessary corrections are included in subsequent editions.
Siemens AG
Division Digital Factory
Postfach 48 48
90026 NÜRNBERG
GERMANY
Programming and Operating Manual (Turning)
01/2017
300
Value assign- Information
ments
Kinematic transformation (avail-
able only if configured according-
ly)
Kinematic transformation (avail-
able only if configured according-
ly)
Disables all the kinematic trans-
formations
Programming
TRACYL(20.4) ; separate
block; cylinder diameter:
20.4 mm
TRACYL(20.4,1) ; also
possible
TRANSMIT ; separate
block
TRANSMIT(1) ; also pos-
sible
TRAFOOF ; separate
block
Programming and Operating Manual (Turning)
01/2017