List Of Instructions - Siemens SINUMERIK User Manual

Programming example
N10
N20
N30
N40 MSG("DRAWING NO.: 123677")
:50 G54 F4.7 S220 D2 M3
N60 G0 G90 X100 Z200
N70 G1 Z185.6
N80 X112
/N90 X118 Z180
N100 X118 Z120
N110 G0 G90 X200
N120 M2
A.13

List of instructions

The functions below marked with an asterisk (*) are active at the start of the program in the turning variant of the control
system, unless otherwise programmed or the machine manufacturer has preserved the default setting for the "turning"
technology.
Address Significance
D Tool offset number
F Feedrate
F Dwell time (block with
G4)
F Thread lead change
(block containing G34,
G35)
G G function
(preparatory function)
G group:
G0 Linear interpolation at rapid traverse rate
G1 * Linear interpolation at feedrate
288
; G&S company, order no. 12A71
; Pump part 17, drawing no.: 123 677
; Program created by H. Adam, Dept. TV 4
;Main block
; Block can be suppressed
; End of program
Value assign- Information
ments
0 ... 9, only inte- Contains compensation data for
ger, no sign a particular tool T... ; D0 indi-
cates no compensation for the
tool, one tool activates 1~9 num-
bers, that is, one tool carries at
most nine different compensa-
tion data at the same time.
0.001 ... 99 Path velocity of a tool/workpiece;
999.999 unit: mm/min or mm/revolution
depending on G94 or G95
0.001 ... 99 Dwell time in seconds
999.999
0.001 ... 99 in mm/rev
999.999
Only integer, The G functions are divided into
specified values G groups. Only one G function of
a group can be programmed in a
block.
A G function can be either modal
(until it is canceled by another
function of the same group) or
only effective for the block in
which it is programmed (non-
modal).
1: Motion commands (type of
interpolation), modally effective
2
Programming and Operating Manual (Turning)
Programming
D...
F...
G4 F...; separate block
See G34, G35
G...
or symbolic name, e.g.:
CIP
G0 X... Z...
G1 X...Z... F...
01/2017