Screenshots of the complete program
Screen 1:
224
13.
Move the cursor to "C" in the line for CYCLE95 with the cursor keys and press this softkey
to insert a marker.
14.
Use the cursor keys to select the entire program block for CYCLE95. Press this softkey to
copy the selection to the buffer memory.
15.
Place the cursor on the end-of-block character after "M3 S2000" with cursor keys and press
this key on the MCP to enter a new line.
16.
Paste the content of the buffer memory into the new line.
17.
Press this softkey to open the window for CYCLE95 again. Move the cursor to the input field
of "VARI".
18.
Press this key to change the value to "5".
19.
Press this softkey to accept the change and continue to enter the following program blocks:
G0 X100 Z100
M05
M30
Then you can proceed with the operations for "program simulation and execution
(Page 242)".
Screen 2:
Programming and Operating Manual (Turning)
01/2017