Other Common Operations; Program Control Functions; Program Test; Dry Run Feedrate - Siemens SINUMERIK User Manual

10

Other common operations

10.1

Program control functions

You can perform further program control operations through the following operation:
+ →
10.1.1

Program test

10.1.2

Dry run feedrate

Programming and Operating Manual (Turning)
01/2017
10. Press this softkey to add the calculation result to the value in the input field at the current
cursor position and close the pocket calculator automatically.
Note:
For more information about how to use the pocket calculator, see Section "Pocket calculator
(Page 75)".
With this softkey activated, the part program is executed with no axis or spindle movement. In this
way, you can check the programmed axis positions and auxiliary function outputs of a part program.
This softkey functions the same as the following key on the MCP:
With this softkey activated, all traversing motions are performed with the dry run feedrate defined in
SD42100 DRY_RUN_FEED. You can set the dry run feedrate in the JOG data setting window
through the following operation:
+ →
51