Siemens SINUMERIK User Manual page 198

Cavity contour
The following example describes how to process a cavity profile and how to define the subroutine of a contour with the
contour functionality.
G500 G18 G95
G0X50
Z100
T5
M4S1500
G0X50Z0.5
198
4. Press one of the following two softkeys. The program automatically jumps to the program
editor screen form.
If you desire to edit and store the contour in a subroutine, press this softkey.
If you desire to edit and store the contour as a section of a main program, press this softkey.
Note:
For more information about programming in the contour editor, see Section "Free contour
programming (Page 269)".
5. Press this softkey to return to the window for CYCLE95 and enter the parameters as de-
sired.
6. Confirm your settings with this softkey. The cycle is then automatically transferred to the
program editor.
Note:
The cycle program created as a section of the main program must be stored after the M30
command.
7. If you desire to recompile the cycle, press this softkey.
Programming and Operating Manual (Turning)
01/2017