ABB IRC5 Product Manual page 57

Connecting power supply 230V 10A to Drive Module
The following procedure details how to connect power supply to the Drive Module.
3HAC027707-001 Revision: D
2.5.2. Connecting power supply to the IRC5 Panel Mounted Controller
Action
1. Route the power supply 230V 10A
cable as shown in the illustration to the
right.
CAUTION!
Route and strap the power supply
230V 10A cable so it will not be
pinched by the cooling flange when
closing the front.
CAUTION!
Separate the power supply 230V 10A
wires from the 3x262V 10A wires.
These are disturbing on the Line filter
LOAD side.
2. Connect the power supply 230V 10A
to the Drive system power supply
connector X1.
• phase 1 to G1.X1:1
• earth to G1.X1:3
• phase 2 (N) to G1.X1:5
2 Installation and Commissioning, IRC5
Note/Illustration
xx0600003317
xx0600003318
• A: incoming power 3x262V 10A
• B: power supply 230V 10A
Continued
Continues on next page
55