Installation Of I/O, Gateways And Encoder Interface Units, Irc5 - ABB IRC5 Product Manual

2 Installation and Commissioning, IRC5

2.9.4. Installation of I/O, Gateways and encoder interface units, IRC5

2.9.4. Installation of I/O, Gateways and encoder interface units, IRC5
Location
The I/O units, Gateway or encoder interface units to be installed are shown in the illustration
below.
xx0600003256
A
B
Required equipment
Equipment
I/O units, Gateways or encoder
interface units
Application manual - DeviceNet
Circuit Diagram
Fitting
The procedure below details how to fit the units.
94
I/O units, Gateways or Encoder interface units
Mounting rail
Action
1.
DANGER!
Before any work inside the cabinet, please
observe the safety information in section
DANGER - Make sure that the main power
has been switched off! on page
2. Fit the I/O unit by snapping it onto the
mounting rail.
3. Connect the DC supply to the board.
4. Connect wires to the inputs and output
connectors as required.
Art. no.
3HAC020676-001
Note/Illustration
26.
Detailed in the Application manual for the
respective busses.
3HAC027707-001 Revision: D
Note
Specified in Definition of
I/O units, IRC5.
See Circuit Diagram on
page 195