Fujitsu ETERNUS DX100 S4 Basic Operation Manual page 118

Hybrid
Hide thumbs Also See for ETERNUS DX100 S4:
Table of Contents

Advertisement

Chapter 7
Troubleshooting
7.1
Check List
When the Server Does Not Recognize the Volumes
Check the points that are shown below. If the problem cannot be resolved, leave the ETERNUS DX alone and
contact your maintenance engineer.
Check the status of the ETERNUS DX and other devices such as network devices connecting the server and
the ETERNUS DX, and ensure that there are no problems with the power supply.
Check if an error occurs in a path by using a path management tool such as ETERNUS Multipath Manager.
Refer to the relevant manuals and take the required actions.
When a Server HBA Fails and Needs to Be Replaced
This section explains the procedure that is required when the HBAs on the server need to be replaced due to
an FC card failure.
Only an overview of this procedure is provided here. For details, refer to related manuals.
Identifiers such as WWNs and IP addresses of ports persist even after CMs, CAs, and ports of the ETERNUS
DX are changed.
FC/FCoE Card Replacement
The following procedure explains how to replace the FC/FCoE card.
1
Use ETERNUS Web GUI or ETERNUS CLI to check the WWN, the host affinity and the other settings of the
FC/FCoE card that is to be removed, and then record the settings.
2
Replace the FC/FCoE card on the server.
(1)
Turn off the server where the FC/FCoE card is to be replaced.
(2)
Replace the FC/FCoE card.
3
Use ETERNUS Web GUI or ETERNUS CLI to specify the required settings.
(1)
Change the WWN, host affinity, and other settings of the removed FC/FCoE card.
Set the WWN, host affinity, and other settings of the new FC/FCoE card by referring to the informa-
tion recorded in
(2)
When a switch is used, the WWN zoning settings need to be changed. For details on this setting,
refer to relevant manuals of the switch.
4
After completing the settings, confirm that access from the server is available.
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Step
1.
118
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus dx200 s4Eternus dx100 s3Eternus dx200 s3

Table of Contents