Fujitsu ETERNUS DX100 S4 Basic Operation Manual page 102

Chapter 5 Component Expansion/Function Enhancement
5.3 Installing Long Wave SFP+ Modules (16Gbit/s)
4
Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
5
Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module (16Gbit/s) that
is to be replaced.
Push the tab on the FC cable connector and pull out the cable.
Make sure to record the connecting port for the disconnected FC cable.
6
Remove the Short wave SFP+ module (16Gbit/s).
(1)
Open the Short wave SFP+ module (16Gbit/s) lever upward.
(2)
Pull the Short wave SFP+ module (16Gbit/s) straight out of the port cage.
Make sure to store the removed Short wave SFP+ module (16Gbit/s) with the fixing lever and the
connector cover attached.
7
Install the Long wave SFP+ module (16Gbit/s).
(1)
Remove the connector cover attached to the port of the Long wave SFP+ module (16Gbit/s) and
open the lever.
Keep the removed connector cover in a safe place where they will not be lost.
(2)
Check the direction of the Long wave SFP+ module (16Gbit/s) and insert it all the way into the
port gauge.
(3)
Close the Long wave SFP+ module (16Gbit/s) lever downward.
8
Connect the FC cable that is disconnected in
Connect the FC cable connector to the FC port on the Long wave SFP+ module (16Gbit/s).
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
SFP+ module
Lever
102
Copyright 2017 FUJITSU LIMITED
Step 5.
P3AM-7662-09ENZ0